Commands, Command list – A&D GR Series GR-300 User Manual
Page 58
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
16. Commands
Command list
...............................................ij»>i .«rf*.TAmiiii«.ifciiMiiI-..:,- ...».¿AaAa i
--------■
I ■
..... ........ .............
Commands to request weighing data
c
Cancel command for the SIR command.
Q
Query command for weighing data.
S
Request command for stable weighing data.
SI
Query command for weighing data.
SIR
Request command for continuous weighing data.
Commands to control the balance
CAL
Calibration command.
MCL
Command to delete all stored data.
MD:nnn
Command to delete data of data number nnn.
OFF
Display OFF command.
ON
Display ON command.
P
Same as the
ON:OFF key, Display ON/OFF command.
PRT
Same as the
PRINT key.
R
Same as the
RE-ZERO 1 key, RE-ZERO command.
RNG
Same as the
RANGE key. Range command.
TST
Calibration test command.
U
Same as the
MODE key. Unit command.
Commands to request stored data
?MA
Output command to transmit all memory data.
?MQnnn
Request command to transmit data of data number nnn.
?MX
Query command for last data number.
nnn ; numerical value of three figures
Serial Interface
page 57
16, Command