A&D GR Series GR-300 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Transmitting All data at One Time
Step 1 Setup the RS-232C interface using "S
i f ”
of the function table.
Step 2 Press andholdthej PRINT [key until displaying |,-
[ [ H i i
land release the key
Step 3 Press the RANGE key to display
LI U L
Step 4 Press the ¡PRINT key to enter this mode.
Step 5 Press the RE-ZERO key. Then the balance displays
o u t b o
Step 6 Press the [ PRINT key to transmit all data to RS-232C interface.
Step 7 The balance displays
, j j F R r
after the finish.
Step 8 Press the jCAL key to return to weighing mode.
The Data Number
When the "Data number output
(г/
-
no)
is set to " /" and the data that is
stored in the balance memory is to be output, the "Data number" can be
appended just before each data. This format consists of six characters
(excluding the terminator).
N 0 .
0 0 1 '-p
S
t
I,
-f 0 0 0
Deleting All Data at One Time
Step 1 Press andholdthej PRINT ¡key until displaying
Г Г Г/
I I
I
L L и L L
and release the key.
Step 2 Press the j RANGE key several times to display
[ j t n r
Step 3 Press the , PRINT key to enter this mode.
Step 5 Press the , RE-ZERO key. Then the balance displays
/ U
LI
Step 6 Press the ¡PRINT key to delete all data.
Step 7 The balance displays
r [ [ n i L
I
after the finish
Step 8 Press the |CAL, key to return to weighing mode.
Data Memory Function
Page 48
Functions