Ditch Witch JT9 - Manual (Page 122)

JT9 Operator’s Manual
Complete the Job - 121
Rinse Equipment
CMW
®
Reclaim Antifreeze
1. Start drilling unit and run at low throttle.
2. Move carriage to front of drill frame.
3. Position 3-gal (11-L) bucket under spindle.
4. Turn drilling fluid pump on low speed.
5. Turn drilling fluid pump off when drilling fluid comes out of spindle.
6. Pour antifreeze into onboard tank.
Rinse Equipment
Using Optional Washwand
Connect the washwand at quick connect (1) at
rear of unit. Open valve (2) to start water flow.
Close valve to stop water flow.
IMPORTANT: Antifreeze can be removed from antifreeze tank and disposed of properly or it can be
reused until it is too diluted with drilling fluid to protect against freezing.