As needed, Drilling unit, Jt9 operator’s manual – Ditch Witch JT9 User Manual
Page 152
JT9 Operator’s
Manual
Service - 151
As Needed
CMW
®
As Needed
Drilling Unit
Change Auto Lubricator TJC Pail
Check pipe auto lubricator TJC level and change
pail as needed.
To change pail
1.
Remove wingnuts and bolts attaching base ring
(4) to pail cover (1).
2.
Rotate base ring slightly to clear hooks on
cover and remove pail from cover.
3.
Remove follower plate (3) from empty pail and
install into new pail. Press firmly on follower
plate until TJC comes up in center opening.
4.
Remove base ring from empty pail and install onto new pail.
5.
Install pail into place over pump dip tube. Use hooks on cover to support base ring.
6.
Install bolts and wingnuts.
7.
Remove cap (2) from discharge tee on pump. Operate pump until discharged TJC is free of air
pockets. Replace cap.
Location
Task
Notes
DRILLING
UNIT
Clean engine cooling system
Change pipe auto lubricator pail
TJC
Change hydraulic filter
Any time system is opened
Check front pipe guide inserts
Check track tension and condition
Change air filter
Check saver sub
Inspect muffler
Replace fuses
NOTICE: Use only genuine Ditch Witch
®
tool joint compound to maintain warranty. See “Recommended