Review modes, Diagnostic code interpretation, Review modes diagnostic code interpretation – Ditch Witch JT2020 User Manual
Page 149
Systems and Equipment - 148
JT2020 Mach 1 Operator’s Manual
Interpret Diagnostic Codes
CMW
Review Modes
Diagnostic Code Interpretation
Diagnostic codes are displayed through a series of light flashes and pauses. Count number of flashes and
pauses to interpret code.
Example: “Flash, flash, flash, pause, flash, flash, longer pause” represents code 32.
Tips for interpreting codes:
•
In View All Codes mode, the green control cycle light will come on the first time the red diagnostic light
flashes a code. The green control cycle light will then go off and the red diagnostic light will flash the
code two more times.
•
Codes are displayed from lower to higher numbers.
•
Code 11 is not used.
•
Code 12 signals successful entry into and exit from review mode.
IMPORTANT: Do not turn off ignition. Diagnostic codes are cleared each time ignition is turned off.
View All Codes
View Codes Individually
1.
Ensure that engine is running and no one is
sitting in operator’s seat.
2.
Press and hold the
resume button for two
seconds.
3.
Diagnostic light will flash code 12 (flash,
pause, flash, flash, longer pause) to indicate
review mode is operational.
4.
After flashing code 12, all diagnostic codes
detected since the last time the ignition was
turned on are flashed three times each.
5.
To save diagnostic codes, continue normal
operation. Do not turn ignition off.
6.
Once the problem has been corrected, clear
all codes by turning ignition off.
1.
Ensure that engine is running and no one is
sitting in operator’s seat.
2.
Press and hold the
set button for two
seconds.
3.
Diagnostic light will flash code 12 (flash,
pause, flash, flash, longer pause) to indicate
review mode is operational.
4.
After code 12 is flashed, press
set button to
see first code.
•
Press
resume to see same code again or
press
set to see next code.
•
Continue pressing
set until all diagnostic
codes detected since the last time the
ignition was turned on are flashed.
5.
To save diagnostic codes, continue normal
operation. Do not turn ignition off.
6.
Once the problem has been corrected, clear
all codes by turning ignition off.