Rinse equipment, Using washwand – Ditch Witch JT2020 User Manual
Page 157
Complete the Job - 156
JT2020 Mach 1 Operator’s Manual
Rinse Equipment
CMW
Rinse Equipment
Using Washwand
Connect the washwand at quick connect (1) at rear of
unit. Open valve (2) to start water flow. Close valve to
stop water flow.
Spray water onto equipment to remove dirt and mud. Some pressure might be needed to remove dried
mud from wrench area.
Incorrect procedures could result in death, injury, or property damage.
Learn to use equipment correctly.
NOTICE: Failure to prime the drilling fluid pump will cause flow fluctuations, which will
make it difficult to control the washwand. For instructions, see “Prime Drilling Fluid Pump”
Pressurized fluid or air could pierce skin and cause injury
or death. Stay away.
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged. Wipe
down instead.