Labconco WaterPr BT Systems 90151 Series - Manual (Page 17)

Installation
9
Connection of the Power Cord − Turning on the System Power
A • Open the front cover of the system (this may require to remove the
final filter).
• This will allow the system to go into STANDBY mode once the
system is powered.
B • Plug the Power Cord into the system.
• Plug the other end of the Power Cord into an appropriate source of
electrical power (i.e. wall outlet).
• Open the Feedwater Supply Valve.
Start-up Displays
C • Once the system is powered, the system will start to display
information before going into STANDBY mode.