Labconco XPert Nano Enclosures 38876 Series - Manual (Page 28)

Product Service 1-800-522-7658 23
Chapter 5:
Using the Nano Enclosure
Now that the installation of your Nano enclosure is completed, you are ready to
use your Nano enclosure.
Read this chapter to learn about:

Routine Daily Work Procedures

Appropriate ULPA Filter Applications, Suitability and Guidelines

Optional Ionizer

Prohibited Acid Use
Routine Daily Work Procedures
Planning

Arrange for minimal disruptions, such as room traffic or entry into the
room while the enclosure is in use.
Start-up

Turn on exhaust system and light.

Only raise the sash for loading and cleaning.

Check the baffle air slots for obstructions.

Allow the enclosure to operate unobstructed for 1 minute.

Wear a long sleeved lab coat and rubber gloves. Use protective eyewear.
Wear a protective mask if appropriate. Consult your Safety Officer for
additional personal protective equipment recommendations.
Loading Materials and Equipment

Load only the materials required for the procedure. Do not overload the
enclosure.

Do not obstruct the air foil, or rear baffle slots.

Large objects should not be placed close together and should be elevated
above the work surface to permit airflow to sweep under the equipment.

After loading, wait one minute to purge airborne contaminants from the
work area.