Labconco XPert Nano Enclosures 38876 Series - Manual (Page 50)

Chapter 7: Accessorizing the Nano Enclosure
Product Service 1-800-522-7658 45
NOTE: The cutout can also be made with a reciprocating saw and a 1/8" diameter
bit. The centerline of the cutout is located 3.3" from the left side and 4.2"
from the bottom. The 1/8" mounting holes are spaced 4.38" apart top to
bottom and centered over the cutout. The cutout dimensions are 2.43"
wide by 4.13" tall.
2.
Canopy Exhaust Connection for Ducting to Outside
Canopy Exhaust connects to the filtered enclosure with integral motorized
impellers from the top so the duct can be routed up and outside the building.
The Canopy Exhaust is available for 6" nominal duct on 2', 3' and 4' sizes and
10" nominal duct on 5' and 6' sizes. The Canopy Exhaust Connection should
be sealed to the top of the enclosure with silicone sealant to prevent leaks. See
Figure 3-3 and Figure B-3.
Order the following:
Part Description
3924400 2' Canopy Exhaust Connection (6")
3924401 3' Canopy Exhaust Connection (6")
3924402 4' Canopy Exhaust Connection (6")
3924403 5' Canopy Exhaust Connection (10")
3924404 6' Canopy Exhaust Connection (10")
3.
Remote Blowers
Has a 1/4 hp direct drive motor and corrosion-resistant epoxy-coated steel
housing and wheel with blower inlet of 6.00" ID. Outlet dimensions are
4.25" x 7.38" OD.
CFM @ Static Pressure-Inches of H
2
O
S.P. 0.0" 0.125" 0.25" 0.50" 0.75" 0.87"
CFM 595 560 515 420 300 167
Catalog
#
Description
Shipping Wt.
(lbs/kg)
4863500 Remote Blower, 115 V, 60 Hz. 4.4 amps 35/16
4863501 Remote Blower, 115/230 V, 50 Hz, 5.6/2.8 amps 35/16
7053501
Explosion-Proof Remote Blower, 115 V, 60 Hz,
4.4 amps
40/18