Labconco XPert Nano Enclosures 38876 Series - Manual (Page 48)

Chapter 6: Maintaining the Nano Enclosure
Product Service 1-800-522-7658 43
Trace Odor Carbon Filter Installation
In the event that low volumes of solvents are required, a Trace Odor Carbon Filter
can be installed.
1. Remove the screws (2) located on each side of the upper diffuser.
2. Lift and remove the upper diffuser.
3. Place the Trace Odor Carbon Filter on top of the HEPA filter with the gasket-
side DOWN. Use care when maneuvering past the airflow sensor. Be careful
not to harm the HEPA filter media that is exposed.
4. Replace the upper diffuser.
5. Replace all screws.
Upper Diffuser
Trace Odor
Carbon Filter
Airflow Sensor