Labconco XPert Nano Enclosures 38876 Series User Manual
Page 30
Chapter 5: Using the Nano Enclosure
Product Service 1-800-522-7658
25
Optional Ionizer
The XPert Nano’s optional built-in ionizer is designed to control static charge on
surfaces within the enclosure. The discharge of the ionizer is uniquely located at
the front face of the work surface, safe from the contaminants and cleaning within.
The emitters within the ionizer have a finite life and therefore there may be times
when one might choose to use the enclosure with the ionizer OFF. The
Blower/Ionizer control switch allows the blower to be operated independently of
the ionizer. Push the top of the switch to activate the blower only; push the bottom
to energize the ionizer along with the blower. The green light adjacent to the
ionizer emitters (on the face of the work surface) will illuminate when the ionizer
is active.
Refer to the Maintenance section of this User’s Manual to keep the ionizer
working at its full potential. Cleaning of the emitter points is recommended every
two to three months (based on 8-hr daily operation).
ATTENTION: NEVER operate the enclosure in an explosive
environment. The ionizer may cause detonation. NEVER
operate the ionizer without the emitter points installed; damage
will occur.
!