Nisus Writer Pro - Manual (Page 149)

Creating Documents 129
Set the margins by “stepping” through pre-set increments
You can change the location of the margins by clicking the “steppers” in the Margins palette of
Nisus Writer Pro. Because you make these changes numerically, but by increments, you might
want to have your document displayed in Page View before you proceed so you can see the result.
1. Open the Tooldrawer and select the Sections palette group from the icons at the top, or, choose
the menu command Window > Palettes > Margins as explained in “Set the margins
numerically” on 127.
2. Click the “stepper” as illustrated in Figure 22 on page 19 until you arrive at your desired value.
The “steppers” increase and decrease in increments of
• .10 cm
• .10 inches
• .10 mm
• .10 pc
• .10 pt
!
This increases or decreases the margins of all selected sections relative to one another by the
increments adjusted in the “steppers”.
Mirror page placement
You may want to print your document for binding so that the text appears on both sides of a piece
of paper. In that case you would probably want your margins to “mirror” or “reflect” depending on
whether they are on the odd or even page.
1. Open the Tooldrawer and select the Sections palette group from the icons at the top, or, choose
the menu Window > Palettes > Section as explained in “Set the margins numerically” on 127.
2. Click Use Facing Pages.
Figure 146
The Section palette showing Page, then Section numbering options