Pilz PMCprimo Drive2.01/21/5/230-480V - Manual (Page 18)

9 Project window
9 Project window
9.1 Setup
9.1.1 Basic setup
Regeneration resistor [ PBALRES ]
Internal The internal regeneration resistor is used.
External An external regeneration resistor, connected to the terminals +R
bext
and -R
B
, is
used.
Ohm - PMCtendo DD5 and PMCprotego D only
Sets the value of the regeneration resistor in unit Ohm.
Max. Regeneration Power [ PBALMAX ]
Set the maximum Regen Power.
Max. Mains Voltage [ VBUSBAL ]
This parameter is used to adjust the regeneration and switch-off levels of the servo amplifiers
to suit the mains power supply voltage or the system conditions for multi-axis systems with
parallel-connected DC-link circuits.
Response to Loss of Input Phase [ PMODE ]
Handles the message „Phase missing“.
Hardware [ HVER ]
Display the version and revision level of the servo amplifier hardware.
Firmware [ VER ]
Display the version and revision level of the servo amplifier firmware.
Name [ ALIAS ]
Here you can assign a name (8 chars max.) to the servo amplifier.
Serial Number [ SERIALNO ]
Display the serial number of the servo amplifier.
Run Time [ TRUN ]
Display the operational time of the servo amplifier, saved at 8 min. intervals.
Page 18 User Manual for Setup Software PDrive