Error control, Number of addresses to write and read – Altera Cyclone V GT FPGA User Manual
Page 34
6–12
Chapter 6: Board Test System
Using the Board Test System
Cyclone V GT FPGA Development Kit
September 2014
Altera Corporation
User Guide
■
Write (MBps)
, Read (MBps), and Total (MBps)—Show the number of bytes of
data analyzed per second.
■
DDR3x40—The theoretical maximum bandwidth is 3200 MBps.
■
DDR3x64—The theoretical maximum bandwidth is 4800 MBps.
Error Control
This group displays data errors detected during analysis and allows you to insert
errors:
■
Detected errors
—Displays the number of data errors detected in the hardware.
■
Inserted errors
—Displays the number of errors inserted into the transaction
stream.
■
Insert Error
—Inserts a one-word error into the transaction stream each time you
click the button. Insert Error is only enabled during transaction performance
analysis.
■
Clear
—Resets the Detected errors and Inserted errors counters to zeros.
Number of Addresses to Write and Read
This control allows you to determine the number of addresses for each iteration of
reads and writes.