The hsma tab, Start, stop, The hsma tab –13 – Altera Cyclone V GT FPGA User Manual
Page 35: Start, stop –13
Advertising
Chapter 6: Board Test System
6–13
Using the Board Test System
September 2014
Altera Corporation
Cyclone V GT FPGA Development Kit
User Guide
The HSMA Tab
The HSMA tab (
) allows you to perform loopback tests on the HSMA
transceiver (XCVR), HSMA LVDS, and CMOS ports
.
HSMA stands for high-speed
mezzanine card for Port A.
1
You must have the loopback HSMA installed on the HSMC Port A connector for this
test to work correctly.
The following sections describe the controls on the HSMA tab.
Start, Stop
The Start and Stop controls at the bottom-right of this tab allow you to start and stop
testing for all three ports.
Figure 6–8. The HSMA Tab
Advertising