General user input/output, Jumpers, General user input/output –18 – Altera SDI HSMC User Manual
Page 26: Jumpers –18, Figure 2–10
Advertising
2–18
Chapter 2: Board Components
General User Input/Output
© July 2009 Altera Corporation
General User Input/Output
This section describes the user I/O interface to the board.
Jumpers
The board jumper switches are CD_MUTE channels 1 and 2 and EQ_BYPASS channels 1
and 2. In the factory default board configuration, jumpers are installed on the
CD_MUTE
jumper switches (J4 and J6) and not installed on the EQ_BYPASS jumper
switches (J5 and J7). When jumpers are not installed on J5 and J7, the EQ_BYPASS
signal can be controlled from the host device.
lists the jumper descriptions and schematic signal names.
Figure 2–10. AES3 TX Channel Block Diagram
Isolation
Transformer
Resistor
Termination
AES3 TX
RS422
Driver
RC
Network
Advertising