Altera SDI HSMC - Manual (Page 27)

Chapter 2: Board Components 2–19
Components and Interfaces
© July 2009 Altera Corporation SDI HSMC Reference Manual
Table 2–12 lists the jumper component reference and the manufacturing information.
Components and Interfaces
This section describes the SDI HSMC interface.
The SDI HSMC contains an Altera standard HSMC connector to connect to a host
board. All the other connector interfaces on the SDI HSMC are connected to the
HSMC connector.
Figure 2–11 , Figure 2–12 , and Figure 2–13 show the pin-outs of the HSMC connector
for banks 1, 2, and 3, respectively.
Table 2–11. Jumper Descriptions and Schematic Signal Names
Board
Reference
Schematic
Signal Name Description I/O Standard
J4 CD_MUTE2 Carrier detect jumper switch which connects to RX channel 2
(CD_MUTE2) on U8. This jumper is normally installed. Signal short
J5 EQ_BYPASS2 Equalizer bypass for RX channel 2. The equalizer can be bypassed
manually when EQ_BYPASS2 signal is tri-stated. This jumper is
normally not installed and the switch is controlled by asserting the
EQ_BYPASS2
signal. A high signal bypasses the SDI receiver equalizer.
CMOS
J6 CD_MUTE1 Carrier detect jumper switch which connects to RX channel 1
(CD_MUTE1) on U10. This jumper is normally installed. Signal short
J7 EQ_BYPASS1 Equalizer bypass for RX channel 1. The equalizer can be bypassed
manually when EQ_BYPASS1 signal is tri-stated. This jumper is
normally not installed and the switch is controlled by asserting the
EQ_BYPASS1
signal. A high signal bypasses the SDI receiver equalizer.
CMOS
Table 2–12. Jumper Component Reference and Manufacturing Information
Board Reference Device Description Manufacturer
Manufacturer
Part Number Manufacturer Website
J4, J6 Jumper Shunt AMP/Tyco 881545-2 www.tycoelectronics.com