Subaru 2003 Legacy - Manual (Page 213)

5
Audio
5-29
– CONTINUED –
B
FM/AM selection button
Press the “FM/AM” selection button
1
to choose either FM or AM
broadcasts. The display will show FM or AM accordingly.
Use the tuning dial to select the station to which you wish to listen.
B
Manual tuning
Turn the tuning dial
3
outer tuner to increase or decrease the recep-
tion frequency in individual steps.
FM band: 0.2 MHz steps
AM band: 10 kHz steps
B
Seek tuning (SEEK)
If the Tuning dial
3
outer tuner is turned for longer than half of a se-
cond, the radio will begin to automatically search for receivable fre-
quencies and will stop at the first one found. This function may not be
available, however, when radio signals are weak. In such a situation,
perform manual tuning to select the desired station.
B
Scan tuning (SCAN)
Press the “SCAN” button
4
to change the radio to the SCAN mode. In
this mode, the radio scans through the radio band until a station is
found. The radio will stop at the station for five seconds while display-
ing the frequency, after which scanning will continue until the entire
band has been scanned.
Turn the tuning dial
3
inner tuner again to cancel the SCAN mode
and to stop on any displayed frequency.
Scan tuning may not function properly if the station reception is weak-
ened by distance from the station or proximity to tall buildings and
hills.
B
Preset tuning
Press any one of the preset buttons
5
to select the corresponding,
previously-registered radio station. The LED at the top of that button
will turn on.
n Manual preset
D Use the tuning dial 3
to select the radio station which you wish to
register.