Subaru 2003 Legacy - Manual (Page 431)

11
Maintenance and service
11-59
– CONTINUED –
5. To install the bulb to the headlight assembly, turn it clockwise until
it clicks.
6. Install the headlight bulb cover.
B
Except GT and OUTBACK models
HBB046BA HBB045BB
1. Disconnect the electrical connector while pressing the lock release
tab.
2. Remove the bulb holder from the headlight assembly by turning it
counterclockwise.
3. Remove the bulb from the headlight assembly.
4. Install the new bulb.
5. Install the bulb holder in the headlight assembly by turning it clock-
wise until it locks.
6. Remove the electrical connector.
J
Front fog light (if equipped)
It may be difficult to replace the bulbs. Have your SUBARU dealer
replace the bulbs if necessary.
J
Front turn signal light, parking light and side marker
light
The headlight assembly must be removed before the front turn signal
light and parking light bulbs can be replaced. When the headlight as-
sembly has been removed and then reinstalled, it may become neces-
sary to make a headlight aiming adjustment. After a bulb has been re-
placed, it is recommended that the headlight aiming adjustment be