Subaru 2003 Legacy - Manual (Page 47)

1
Seat, seatbelt and SRS airbags
1-23
– CONTINUED –
then pull it out slowly again.
3. Insert the tongue plate into the buckle until you hear a click.
4. To make the lap part tight, pull up on the shoulder belt. And place
the lap belt as low as possible on your hips, not on your waist.
n Unfastening the seatbelt
HB0303
Push
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted prop-
erly to avoid catching the belt webbing in the door.
B
Rear center seatbelt on wagon model
WARNING
D
Fastening the seatbelt with the webbing twisted can increase
the risk or severity of injury in an accident. When fastening the
belt after it is pulled out from the retractor, especially when
inserting the connector’s tongue plate into the mating buckle (on
right-hand side), always check that the webbing is not twisted.
D
Be sure to fasten both tongue plates to the respective
buckles. If the seatbelt is used only as a shoulder belt (with the
connector’s tongue plate not fastened to the connector’s buckle
on the right-hand side), it cannot properly restrain the wearer in
position in an accident, possibly resulting in serious injury or
death.