Applied Motion RS-232 - Manual (Page 275)

275 920-0002 Rev. I
2/2013
Host Command Reference
Configuring Your Drive
Three Windows programs are available from Applied Motion Products for use with our Ethernet drives.
These programs are included on the CD that accompanies each drive and the most recent version is always
available at www.applied-motion.com.
ST Configurator is used to configure your stepper drive and motor. It can also be used to change the
selection of drive IP addresses. ST Configurator includes extensive built-in help screens and manuals.
Quick Tuner is used to configure and tune servo drives. The Quick Tuner Manual is automatically installed in
the Applied Motion Products program menu when you install Quick Tuner.
Q Programmer will be needed if you want to embed programs in the non-volatile memory of your drive,
either to run automatically at power up or to be triggered by commands sent from a host.