BINDER M 53 - Manual (Page 17)

M (E2) 10/2014 page 17/71
3.4 Location of installation and ambient conditions
Set up the drying and heating oven on a flat, even and non-flammable surface, free from vibration, and in
a well-ventilated, dry location and align it using a spirit level. The site of installation must be capable of
supporting the unit’s weight (see technical data, chap. 15.3). The ovens are designed for setting up inside
a building (indoor use).
CAUTION
Danger of overheating.
Damage to the unit.

Do NOT set up units in non-ventilated recesses.
 Ensure sufficient ventilation for dispersal of the heat.
• Permissible ambient temperature range during operation: +18 °C up to +40 °C / 64.4 °F to 104 °F. At
elevated ambient temperature values, fluctuations in temperature can occur.
The ambient temperature should not be substantially higher than the indicated ambient tem-
perature of +25 °C / 77 °F to which the specified technical data relate. In the case of different
ambient conditions, deviations from the indicated data are possible.
• Permissible ambient humidity: 70 % r.H. max., non-condensing.
• Installation height: max. 2000 m / 6562 ft. above sea level.
When placing several units of the same size side by side, maintain a minimum distance of 250 mm / 9.84
in between each unit. Wall distances: rear 100 mm / 3.94 in, sides 160 mm / 6.29 in.
CAUTION
Danger by stacking.
Damage to the units.

Do NOT place drying and heating ovens on top of each other.
To completely separate the unit from the power supply, you must disconnect the power plug. Install the
unit in a way that the power plug is easily accessible and can be easily pulled in case of danger.
Do not install or operate the high drying and heating oven M in potentially explosive areas.
DANGER
Explosion hazard.
Danger of death.

Do NOT operate the unit in potentially explosive areas.
 KEEP explosive dust or air-solvent mixtures AWAY from the vicinity of the unit.
CAUTION
The exhaust duct will become hot during operation.
Danger of burning.

Do NOT touch the exhaust duct during operation.