BINDER M 53 - Manual (Page 30)

M (E2) 10/2014 page 30/71
9.1 Menu-based program entry
Displays showing the initial normal display in Idle Mode
W X
08:43:55 15.12.13
CONFIG VIEW-> PGM
TEMP
0.0
26.8
°C
HAND
W X
08:43:55 15.12.13
CONFIG VIEW-> PGM
FAN SPEED
50
%
HAND
Hit button PGM. The window program selection appears
Select a program via the arrow keys and confirm by pressing “ENTER”
The following display serves to select a
subroutine:
08:43:57 15.12.13
Prog. Select.
Prog 1 PROG 01
Prog 2 PROG 02
Prog 3 PROG 03
Prog 4 PROG 04
Prog 5 PROG 05
Prog 6 PROG 06
Prog 7 PROG 07
Prog 8 PROG 08
Prog 9 PROG 09
Prog 10 PROG 10
Prog 11 PROG 11
Prog 1 PROG 01
TP- Program 2
TP- Program 3
TP- Program 1
Select the first subroutine “ TP-Program 1” (TP-Program 2 und TP-Program 3 are without function) and
confirm by pressing “ENTER”.
A
program table will appear, which is initially empty until you enter the temperature values. You can now
enter the temperature program.
Temperature at the beginning
of the program section
Fan speed in %
Factory setting:
50% in Idle Mode
100 % in Manual Mode and
Program Mode
Program No. Subprogram TP-Program No. 1
08:43:55 15.12.13
Total number of program
sections
Parameter set (preselected)
Tolerance band limits tem-
perature (maximum and min-
imum temperature)
Operation line 1
(air flap)
Duration of program
section
Number of start section in case
of repeat cycles
Number of duplicates in case
of repeat cycles
DEL PGM
08:43:55 15.12.13
Prog select Fr. Abs. 372
Prog 1 PROG 01 
Prog 2 PROG 02 
Prog 3 PROG 03 
Prog 4 PROG 04 
Prog 5 PROG 05 
Prog 6 PROG 06 
Prog 7 PROG 07 
Prog 8 PROG 08 
Prog 9 PROG 09 
Prog10 PROG 10 
Prog11 PROG 11 
Prog12 PROG 12 
Prog13 PROG 13 
Prog14 PROG 14 
Prog15 PROG 15 
Prog16 PROG 16 
Prog17 PROG 17 