BINDER M 53 - Manual (Page 28)

M (E2) 10/2014 page 28/71
8. Manual Mode
In Manual Mode (HAND) you can enter a temperature set-point, the fan speed (0% to 100%), and the
switching-state of up to 8 operation lines. Operation line 1 is used to control the air flap position. The oth-
er operation lines are non-functional. All settings remain valid in Manual Mode (HAND) until the next
manual change, if the unit had been turned off or in case of toggling to Idle Mode or Program Mode
(AUTO).
8.1 Entering the set point values
W X
CONFIG HAND PGM VIEW->
08:43:55 15.12.13
CONFIG CONFIG CONFIG
FAN
50.0
%
Idle Mode
No heating function.
Fan working at 50% rate (factory set-
ting).
Toggling to Manual Mode
Change of page
Toggling between temperature set-point, fan speed, and operation lines.
Arrow buttons to select the operation
lines (Operation line 1 = air flap)
ON = air flap open
OFF = air flap closed
Arrow buttons
to enter the val-
ue
Button to move the decimal point
Unlock the keyboard locking (option, chap. 11.10) via the key switch to enter the set-point.
08:43:55 15.03.13
HAND
HAND
Hand-Mode
TEMP
SPEED
Steuerkontakte
+29.3 °C
+80.0 %
Hand-Mode
TEMP
FAN SPEED
Operating contacts
+40.0 °C
+50.0 %
PGM CONFIG W VIEW->
EXIT
08:43:55 15.12.13
HAND
08:43:55 15.12.13
Operating contacts
Contact 1
Contact 2
Contact 3
Contact 4
Contact 5
Contact 6
Contact 7
Contact 8
On
Off
Aus
Aus
Aus
Aus
Aus
Off
HAND
Contact 1
Off
On
Hand-Mode
TEMP
FAN
Oper
+40.0 °C
+80.0 %
TEMP
+0060.0 °C
EXIT