8 soil temperature sensor, Standard sensors – Casella CEL Nomad portable weather station User Manual

Page 46

Advertising
background image

The bucket assembly is adjusted to

tip each time an amount of water
proportional to 0.2 mm of rainfall has
collected in one or other side of the bucket.
Therefore, each time the bucket tips, a signal
proportional to precisely 0.2 mm of rainfall is
sent to the logger.

The gauge has a body and funnel

constructed of aluminium alloy, with an
accurately machined “Septum Ring”.

The aluminium base plate is

equipped with levelling screws and a spirit
level for precise adjustment.

6.7.1

Rainfall Sensor Specification

Part number:

187060D

Transducer:

Tipping Bucket

Aperture:

400 cm²

Resolution:

0.2 mm per tip

Accuracy:

±1%

Capacity:

Unlimited

Operating temp:

1°C to 85°C

Supply Voltage:

7 - 20 V DC (supplied from environmental
case)

Power Consumption:

Typically 2-3 mA

Output calibration:

Debounced 0 to 5 V pulses.

Cable:

9 m cable supplied

6.8

Soil Temperature Sensor

This is an additional sensor available for use
with “Special” Nomad Weather Systems.

The soil temperature sensor is

connected by cable to an auxilliary junction
box. Clip this box to the lower part of the
tripod, and connect the output cable to the
7-pin socket in the bottom panel of a special
system environmental case.

The sensor is designed to be installed at any depth, by digging a small

hole to the required depth, locating the sensor then back filling. This technique
avoids the requirement for multi-length probes, and is simpler and more reliable
than attempting to insert long thin probes into hard soil. The sensor may be
used to measure ground surface temperature by installing in the top 1 cm of the
soil sample.

6.8.1

Soil Temperature Sensor Specification

Part number:

120620B

Sensor type:

Semi conductor current generator

Measuring range:

-40°C to 60°C

Calibrated accuracy:

±0.5°C between -20 to + 50°C

Supply voltage:

7 to 15 V

Power consumption:

Typically <1 mA

Output calibration:

Nominally 1.5 V at 0°C and 1.8 V at 50°C

Standard Sensors

02024

Figure 16: Tipping bucket rainfall

sensor

01061

Figure 17: Soil temperature sensor

Page 46 of 68

NOMAD Portable Weather Station

Users Handbook

Advertising