CIRCUTOR MDC-20 User Manual
Page 27
MDC-20
User Manual
Page 27 of 58
Fig.7-7 . – Configuration of counter / meters
Meters: It is possible to configure the following parameters for each of the eight meters:
• Description: Alphanumeric name to identify the meter on the unit screen.
• Unit: Alphanumeric type data to identify the meter units.
• Factor: Multiplier value of each pulse, (for example kWh/impulse ratio)
Flows: Checking the selector
will activate the flow variable. If this selector is not activated, it
will not be possible to view the flow value of the corresponding controller input.
Fig.7-8 . – Configuration of flow meters
To configure the flow meters the following fields must be defined:
• Description: Alphanumeric type data which allows you to enter a brief description of the
flow for better identification.
• Unit: Alphanumeric type data which permits a brief description of the units where the
flow is shown to be entered.
• Factor: Multiplier value of each input impulse, (for example litres/impulse)
• Time (min): Time in minutes for calculating the flow value.
• Calculation window (s): Time window, in seconds, that the software uses to calculate
an estimate of the flow, taking into account the value of the unit 's meter.
Digital inputs: To configure digital inputs, a description must be defined for each of them.