d&b D80 - Manual (Page 30)

Due to the vast functional range and possible settings of the D80
amplifier, this section is intended as a quick reference to provide
you with a systematic procedure for defining the basic settings of
the amplifier.
It is advisable to start with the device settings followed by the
individual channel settings.
System reset
Before starting to define the basic settings, perform a system reset.
1. Switch off the device.
2. Press and hold the encoder and repower the device.
Þ Long confirmation beep.
3. Release the encoder and briefly press the encoder again
within 2 sec.
Þ Short confirmation beep.
The device will boot up and will switch to the Home
screen. A corresponding message will be issued:
1. Device setup
Þ On the Home screen, tap the Device view button.
Þ This will enter the Device setup subscreen with the «Input»
tab being active.
2. Input (Input mode / Input routing)
Þ Define your Input mode and Input routing settings for all
channels correspondingly.
Note: A detailed description of the Input routing is given in
the reference chapter of the Channel setup Þ Chapter 10.6.
"Input routing" on page 56.
A detailed description of the Input mode is given in the
reference chapter Þ Chapter 9.2. "Input" on page 34.
3. Output (Output mode)
Þ Tap the «Output» tab and define your desired output mode
settings for each pair of amplifier channels correspondingly.
Note: A detailed description of the available output modes is
given in the reference chapter Þ Chapter 9.3. "Output"
on page 36
8. Basic settings - Quick reference
d&b D80 Manual 1.9 en 30