d&b D80 - Manual (Page 44)

Home screen Switches to the Home screen.
Levels Switches to the Levels screen.
Edit password
Selecting the «Edit password» option opens an input mask which
enables you to edit or assign a password (upper-case characters
with a maximum length of 7 characters).
Wrong entries can be corrected by tapping the Erase button on the
bottom right ( ).
Tapping «OK» on the top right confirms the entry, closes the input
mask and switches back to the Lock screen.
Tapping the Back button ( ) on the top left exits the input mask
and leaves the previous password unchanged.
Note: The factory default password is: DBAUDIO
Lock
Tapping the «Lock» button confirms any new settings and exits the
subscreen. A corresponding message is displayed.
The device will be switched to the screen selected for Lock mode.
Unlocking the device
If you attempt to change the status of the device while it is in Lock
mode, the following message will be issued: Press encoder for 2s
to unlock. To unlock the device, proceed as follows:
Press ... Press and hold the encoder for a minimum of 2
seconds until the message disappears.
Password 1. Press and hold the encoder for a minimum of
2 seconds until the corresponding input mask
is displayed.
2. Enter the password as described above.
An incorrectly entered password will revert the
device to the screen displayed for Lock mode.
If the password is lost or forgotten, a locked device can be
unlocked by performing a system reset.
d&b D80 Manual 1.9 en 44