d&b D80 - Manual (Page 65)

In addition, a Web Remote interface is integrated which provides
direct access to the user interface of a single amplifier using a
standard web browser.
Note: The user interface of the amplifier can only be
accessed after connecting the amplifier to a computer via
Ethernet. It is possible to connect the computer and the
amplifier directly, however, this requires to manually set static
IP addresses.
For this reason, the use of a router with DHCP server is
recommended for setting up the network connection. If the
router also provides a wireless access point, the amplifier may
also be controlled using mobile devices.
Recommended and tested browser
Windows:
Firefox V 7.0 or higher
Internet Explorer: None
OSX: Safari V 5.0 or higher
Firefox V 7.0 or higher
Internet Explorer: None
iOS: iOS 6 or higher
Android: Mobile Firefox V 27.0 or higher
Remote control
To enable remote control via the Web Remote interface, proceed
as follows:
1. Establish a connection between the etherCON connector of
the amplifier and the router.
Þ Up to three (3) amplifiers may be daisy chained to
connect to one single port of the router.
After a while, the «Remote» tab of the amplifier screen will
display the IP address the DHCP server has assigned to the
device.
2. Type this address into the address field of the browser or the
mobile device that is connected to the network.
Þ In this case:
192.168.11.194
3. For multiple amplifiers, open one browser tab for each
amplifier connected and apply the corresponding IP address.
Web Remote interface page
The Web Remote interface page is split into three tabs: the
«Web Remote», the «Event log» and the «Commands» tabs.
Web Remote
The «Web Remote» tab shows the actual screen of the connected
amplifier.
All screens and screen items can be accessed in the same manner
as on the touch screen by simply clicking the relevant screen item.
The refresh rate can be set to fast or slow.
Refresh
fast
Refresh rate is1 second.
11. Web Remote interface
d&b D80 Manual 1.9 en 65