d&b D80 - Manual (Page 43)

9.5.1.1. Display
The «Display» tab provides the following display options.
Backlight
Enables the following optional settings:
Off The display brightness is set to 1 (minimum
brightness).
On The backlight is permanently on.
Timeout
10s
The display is illuminated when the encoder is
pressed or when the display is touched. The light
switches off automatically 10 seconds after the
last operation.
Note: This setting is recommended to increase the lifetime of
the display.
Brightness
Enables adjustment of the display brightness in the range from 1 to
10. The default setting is 8.
Touch beep
Enables or disables the beep sound when using the touch screen.
Touch screen calibration
Due to mechanical impact or the aging process of the touch
screen, its calibration references may change.
An indication is that when you tap a specific button and the
adjacent button is activated instead or when ap specific button
does no longer work.
In such cases, the touch screen should be recalibrated.
To calibrate the touch screen, proceed as follows:
1. Select «Touch screen calibration».
Þ The Screen calibration menu will open guiding you
through the calibration process.
2. Follow the relevant on-screen instructions.
9.5.1.2. Lock
Selecting the «Lock» tab opens the corresponding subscreen which
enables different protection settings.
Mode
Selecting «Mode» toggles between two options to protect the
device against unintentional operation.
Press knob 2s Prevents accidental operation by locking the
front panel controls.
Password Enables password protection to prevent
operation by unauthorized persons.
Screen
Selecting «Screen» allows two different settings for the screen
when the device is locked.
d&b D80 Manual 1.9 en 43