Junger Audio d07 - Digital Transmission Processor - Manual (Page 12)

A 2 –Installation
The digital audio level processor d07 can transmit specific device statuses via
parallel Tally lines.
use:
monitoring of the d07 status
Connector :
D-SUB 25pin, female
Pin assignment of the connector :
Pin Signal name Functions
1 Tally 1 normally closed
2 Tally 1 normally opened Defined by d07 config
3 TALLY 2 common
4 Tally 3 normally closed
5 Tally 3 normally opened Defined by d07 config
6 TALLY 4 common
7 Tally 5 normally closed
8 Tally 5 normally opened Defined by d07 config
9 Tally 6 common
10 Tally 7 normally closed
11 Tally 7 normally opened Defined by d07 config
12 TALLY 8 common
13 + 5V 110 Ohm
14 TALLY 1 common
15 Tally 2 normally closed
16 Tally 2 normally opened Defined by d07 config
17 TALLY 3 common
18 Tally 4 normally closed
19 Tally 4 normally opened Defined by d07 config
20 TALLY 5 common
21 Tally 6 normally closed
22 Tally 6 normally opened Defined by d07 config
23 TALLY 7 common
24 Tally 8 normally closed
25 Tally 8 normally opened Defined by d07 config
Shiled
Electrical specifications:
GPO (Tally)
potential free relay contact
common / normally closed / normally opened
24V - 1A
125V - 0,5A
P
max
= 62,5VA
Note : An internal auxiliary voltage feed is available on pin 9 via a 110Ohm
resistor. Ground is available from the shield of the connector only!
When using the auxiliary voltage feed, there is no electrical isolation given
anymore and the risk to inject unwanted noise is high!
2.8.2
TALLY OUT