Junger Audio d07 - Digital Transmission Processor User Manual
Page 16
POWER INPUT
IEC mains input connector 85-264V, 50/60 Hz with integrated fuse
REMOTE
serial remote interface RS-422 (232)
connector:
9pin SUB-D, female
GPI
parallel remote interface
TALLY-out
open relais contact
connector:
25pin SUB-D, female
GPI-in
+3,5…+30V potential-free
connector: 15pin SUB-D, female
SYNC
SYNC IN
input for ext. sync signal (AES 3 format, 75 Ohm, unbal)
or video sync signal (blackburst, 75 Ohm, unbal) or
wordclock sync signal, TTL level, unbal
connector:
BNC socket
WCLK OUT
output for word clock (system clock of d07)
connector:
BNC socket
DIGITAL IN
input for AES/EBU standard format
connector:
XLR female panel jack
DIGITAL OUT
output for AES/EBU standard format
connector:
XLR male panel jack
ANALOG IN/OUT
Analog input to 24 bit A/D-converter
Input floating balanced, XLR connector female
Analog output from 24 bit D/A-converter
Output floating balanced, XLR connector m
Some basic settings can be made by switches and jumpers at the internal circuit
boards of the unit. These settings can occur general changes for operation and should
made by qualified engineering staff only.
Internal
To set any internal jumper or switches it is necessary to open the unit.
PLEASE DO NOT MAKE ANY ALTERATIONS WITH THE MAINS STILL
CONNECTED TO THE UNIT!
Loosen the screws on the top cover and remove. Then you can see all jumper and
switches as shown in the drawing below. After setting of jumper or switches
reassemble the unit in opposite order.
3.3
Switches and
Jumpers for
Configuration