Junger Audio d07 - Digital Transmission Processor - Manual (Page 9)

A 2 –Installation
INSTALLATION
The digital audio level processor d07 was carefully packed in the factory and
the packaging was designed to protect the equipment from rough handling.
Please examine carefully the packaging and its contents for any signs of
physical damage, which may have occurred in transit.
The digital audio level processor d07 is a device under the safety category
Schutzklasse 1 in keeping with the VDE 0804 standards and may only used
with power supply installations built according to regulations.
Check the voltage details printed at the rear panel are the same as your local
mains electricity supply.
The digital audio level processor d07 is equipped with standard connectors
(see also chapter 3).
Before connecting the digital audio level processor d07 switch the power off at
all connected units.
The digital audio level processor d07 is made as standard 19“ unit (EIA
format). It occupies 1 RU (44 mm height) space in a rack. Please allow at
least additional 3“ depth for the connectors on the rear panel.
When installing the unit in a 19“ rack the rear side of the unit needs some
support, especially for mounting in flight cases.
The digital audio level processor d07 should not be installed near units which
produce strong magnetic fields or extreme heat. Do not install the audio
processor directly above or below power amplifiers.
If, during operation, the sound is interrupted or displays no longer illuminate, or
if abnormal odor or smoke is detected immediately disconnect the power cord
plug and contact your dealer or Jünger Audio.
2.1
UNPACK THE UNIT
2.2
POWER SUPPLY
2.3
CONNECTIONS
2.4
RACK MOUNTING
2.5
OPERATION
SAFETY
A
2