Televes HD DTT Receiver - Manual (Page 18)

18
High definition DTT adapter
Through this menu you will be able to make the ZAS HD
record an event at a programmed time. Up to 20 different
events can be programmed.
- If no event has been created, the list is shown as empty.
So that this function is possible, an external
hard drive with FAT 32 must be available, a
pen drive or a memory card reader.
Create/add an event
- To add a new event, press the OK key over the option
Timer on the Main Menu.
- Select one of the timers with the cursor or keys or
and press OK to confirm.
Channel: Indicate the channel which will be recorded
once the adapter switches on. The current channel is
shown by default. Select another with the or keys.
Date: Enter the date of the event.
Start time: Enter the start time of the recording.
End time: Enter the end time of the recording.
Repeat: Indicate if this process is to be carried out just
once (“Do not repeat”), “Every day” or “Every week”.
- Then press the OK key on the remote control to activate
the timer.
Delete an event
- A list of programmed events will appear on the “Timer”
menu in both manual format as well as through the EPG
(see sectiono. 7.- Electronic Programme Guide EPG).
- To delete an existing event, position the cursor over the
EPG and press the red key.
- The time shown on the adapter is sent by the
service provider. Very rarely, it might happen
that this time is not correct. Check this before
programming an event.
- During the procedure of a Timer only programmes
of the same Multiplex can be seen.
- Events cannot be created if the start or end times
and lower than the current ones.
- Events cannot be created if the time overlaps.
10. Timers