Televes HD DTT Receiver - Manual (Page 8)

8
High definition DTT adapter
4. Installation of equipment
Different types of televisions and other equipment can be
connected to ZAS HD.
The most common forms of connecting it are shown in
this manual. If you have any problems connecting your
adapter, please contact your vendor.
There are two ways to connect the ZAS HD adapter to your
TV: by SCART lead or HDMI cable. If your TV has a HDMI
connector, use this type of connection to obtain the best
quality image.
When the connection is made using a SCART cable, the
ZAS HD can supply RGB or CVBS signals. By default, the
ZAS HD is already configured to supply the CVBS signal,
as some TVs do not support the RGB output. However, for
optimum image quality, it is recommended to select the
RGB option (as long as your TV is compatible with these
signals). To change the configuration from CVBS to RGB,
do it through the “Video Scart format” (see section 11.2.-
Output adjustments).
- Connect the antenna signal to the RF IN connector of the
ZAS HD.
- Connect the audio and video between the ZAS HD and
the TV via SCART cable or HDMI connection.
- Switch on equipment sets (TV).
- Feed the ZAS HD through the mains adapter.
- Televés recommends using a HDMI cable
category 2.
- If your TV only has a DVI connector, use a HDMI-
DVI adapter. Connect an audio cable for the
sound output.
- All the cables used for the adapter connections
shall be shielded type.
- DO NOT PLUG IN the adapter to the mains
before finishing all the unit connections.
- If you are using an inside antenna, verify
that it is connected to the power supply.
4.1. Connecting to a TV