Xtramus NuApps-MultiUnits-RM Ver1.5 - Manual (Page 48)

4.2.4. Configuring Tasks Listed on List of Selected Tasks
After choosing the tasks you would like to perform from Built-in Tasks as mentioned in “4.2.3.
Adding/Removing Tasks via Task List Setting”, you can start making detail settings with individual
tasks by clicking the task you would like to configure from List of Selected Tasks. All the configurations
for this task will be listed in the right-side section as shown in the figure down below.
Please note that the maximum number of tasks that can be selected into the List of Selected Tasks is
32.
For more detailed information regarding to task settings in NuApps-MultiUnits-RM’s task groups, please
refer to “5. NuApps-MultiUnits-RM Detail Task Setting.”
Click the OK button on the bottom-right side of Option – New Model window when all configurations are
done. A “Save As” window will pop up and prompt you to save all the configurations you made.
The default name for the configuration setting is “config” and will be saved in a folder named after the
DUT’s Model Name. All configuration setting files are saved as XML format, and changing configuration
setting’s file type may cause NuApps-MultiUnits-RM unable to load your previous saved setting file.
NuApps-MultiUnits-RM will apply all the settings you’ve made after saving.
48
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®