Xtramus NuApps-MultiUnits-RM Ver1.5 - Manual (Page 64)

5.4. Unicast Test (UC) _ PT2-UC-10F (10Mbps Full Duplex)
Layer 2 10Mbps Full Duplex Unicast Performance Test is to transmit test streams via point to point
addressing method that is based on MAC address.
A. Port Map
• Source/Destination Port: These two fields display the source/ destination port for the task. Ports
are displayed in IDs in the format of (X, Y, Z) while X is the number of the chassis (which is
displayed on NuStreams-2000i/600i), Y is the slot number where this module card is installed, and
Z is the available port number located on the module card.
• Port Map: This field shows how test streams will be transmitted from port to port.
• Æ : To assign how test streams flow from source port to the destination port, click a port from
Source Port, click a port from Destination Port, and then click Æ button to add them to the Port
Map.
• Å : To remove a port map setting from Port Map, click the setting you would like to remove, and
then click Å button to remove it from Port Map.
• Pair >: NuApps-MultiUnits-RM will match ports located on the same module card in a
back-and-forth manner, and add them to the Port Map.
• Rotate >: NuApps-MultiUnits-RM will match ports so the last port will connect to the first port, thus
forming a loop. If you have the same amount of ports on your chassis and DUT, Rotate allows you
to test all DUT’s ports simultaneously.
• Reset <: Remove all port map settings in the Port Map.
• Window NO: You can view each Window number’s Port Mapping by scroll down this field and
select the Window No of your interest.
• Next: instead of scrolling down the Window NO field, you may click this button to change and
view the next Window’s Port Mapping.
• Traffic Direction Mode: You can scroll down and choose the direction of the traffic on this field.
64
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®