Artesyn System Services Framework Installation and Use (November 2014) - Manual (Page 54)

SSF Installation
System Services Framework Installation and Use (6806800S58E) 54
Note: Make sure the ShelfId is updated as per section Chapter 2, Shelf ID Configuration
3.3.7 Starting SSF on External PC
After completion of the installation, the postgres, radius, and SSF services will be started
automatically.
This section describes how to start the SSF application manually, followed by sections for
starting the Web Interface, SSF Core, Blade SSF Core, and Application agent individually.
3.3.7.1 Starting SSF core on External PC
After completion of the installation, the postgres, radius, and SSF services will be started
automatically.
Use the following commands to start, stop, status and restart the postgres, radius and SSF
services for future use:
1. /opt/ssf/etc/config/S99RunSSFOnLinuxPC.sh start
2. /opt/ssf/etc/config/S99RunSSFOnLinuxPC.sh stop
3. /opt/ssf/etc/config/S99RunSSFOnLinuxPC.sh status
4. /opt/ssf/etc/config/S99RunSSFOnLinuxPC.sh restart
3.3.7.2 Starting Blade SSF Core to connect to External PC
Starting Blade SSF core initiates the bcsimd services, enabling communication between SSF
and the blade on which blade SSF core is installed. You can monitor, manage, and configure the
Linux standard service using SSF interfaces. It also sets the hostname of the blade depending
upon the shelf ID and slot number. By default the host name is non-configurable. If you want to
change the host name, edit /etc/rc3.d/S99SsfBcsimRun<Blade>.sh file and set
SET_HOST_NAME to “Yes”.