Avalon Firestyles 900 PI-1993 to 1996 - Manual (Page 12)

P AGE 12
S
TOVE
I
NSTALLATION
(C
ONT
.)
Horizontal Corner Installation
The horizontal corner installation is often used because it takes up very little space. Make sure to
follow all of the requirements listed in the section "Stove Requirements" as well as those listed
below in the illustration. The steps below detail the order of installation.
HINT: Make sure to carefully plan the pellet vent route so that it always
maintains a 3" clearance to combustibles.
A Install the floor protection.
B Install the pellet vent. Make sure to follow the pellet vent manufacturer's instructions for
passing the vent through combustible walls. Screw together all pellet vent joints and seal.
Install the outside air connection (if applicable).
WARNING: Because this type of installation does not have any vertical rise to
create draft, we recommend using outside air with this type of
installation.
C Place the pellet stove in position and attach the pellet vent and outside air connection (if
applicable). Screw together and seal the pellet vent connection to the stove.
D Read the section "Operating the Heater" prior to plugging in the stove and operating.
Approved thimble
Floor
Protection
Cornerwall
Cornerwall
Door
Opening
0"
6"
2"
Min.
3" Min.
1'
Min.
0"
2" Min.
Outside
Air
Type
"L" Vent
Joints must be
screwed together
and sealed
1'
Min.
Cornerwall
Outside Air Termination
with 90 elbow or hood
Optional Direction
Floor
Protection