Avalon Firestyles 900 PI-1993 to 1996 - Manual (Page 47)

O
PTIONAL
E
QUIPMENT
P AGE 47
C ERAMIC L OG S ET
The log set is included as standard equipment to make the pellet heater appear more like a wood
stove (it is designed for aesthetic purposes only and is not required). The instructions below
detail its installation.
1. The log is placed on a log holder at the front of the firebox. This holder slides
into place. Before installing the log, make sure the holder is properly located.
Side View
Burnpot
Log
Holder
Spacer
These
flanges
hold the log
in place.
Make sure the log holder is
pressed all the way down before
installing the log. To remove the
log holder, pull it upwards.
Back View
2. The log is shipped with the heater. Remove the log from its wrapping and place it
on the log holder (see the illustration below).
Make sure the log fits over the flanges
and is pushed all the way back.
Log
Set
Log Holder
HINT: Inspect the flames after installing the log set. If the flames are sooty,
try re-adjusting the log so the flames can flow around and through
the log set with less resistance. This will cut down the amount of
flyash and soot inside the pellet stove.
NOTE: Remove the log set when cleaning the heater or inspecting the burn
pot (remove the log holder if necessary).