Avalon Firestyles 900 PI-1993 to 1996 - Manual (Page 50)

P AGE 50
O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
I NSERT F RONT S UPPORT
The insert front support is used to support the insert when installed in a raised masonry or zero
clearance fireplace. The instructions below detail its installation.
Packing List:
¥ Support ¥ Support Extension
¥ 2 Screws (for Support Extension) ¥ 2 Leveling Bolts and Nuts
1. Remove the ashpan and
prop the insert up.
Remove the two bolts
located underneath the
front corners of the
insert with a 9/16" open
end wrench (these bolts
are connected to the
brackets used during
shipping). Slide the
tabs on the support into
the space underneath the
insert (see the
illustration to the right).
Attach the support to
the insert with the bolts.
2. Screw the two nuts into
the two leveling bolts
(included with the insert
front support kit). Insert
the leveling bolts into
the lower brackets on
the support and adjust
them to the approximate
height required. Place
the insert in position
and adjust the leveling
bolts to the required
height and lock the bolts
in position by tightening
the nuts against the
support.
3. Place the support
extension around the
support so that it covers
the gap between the
support and the floor.
Use a 5/16" nut driver
to attach the screw
through the elongated
hole on the extension
and into the hole on the
support.
Support
Extension
Place the support extension around the
support and use a 5/16" nutdriver to attach
the screw through the elongated hole on the
extension and into the hole on the support.
Support
Locknut
Leveling
bolt
Support
Lock
Nut
Insert a locknut onto each
leveling bolt, adjust it to the
approximate height, and
attach it to this bracket on
the inside of the support (use
a 9/16" open end wrench).
Insert
Insert
Slide the
tabs on the
support into
this space
here.
Use the bolts
removed from
the shipping
brackets to
attach the
support to the
insert.
Support