Avalon Firestyles 900 PI-1993 to 1996 - Manual (Page 48)

P AGE 48
O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
S TOVE L EGS
There are three different stove legs available for your pellet stove: cast brass; cast black; and,
black steel. The instructions for installing the legs are the same for each type of leg.
Raise the stove by inserting some pieces of lumber in the middle of the stove to a height of about
8". Line up the hole in the top of the leg with the threaded bolt hole in each corner of the stove
bottom. Using a 9/16" open end or socket wrench, fasten the leg to the stove with the supplied
attachment bolts and washers, making sure the legs are flush with the corners of the stove.
Unscrew the leveling bolts enough so the stove will rest on the upper tips, not the metal portion
of the legs. Lower the stove down.
Attach Bolt (with
washer) to Stove
From Below Attach Bolt (with
washer) to Stove
From Below
To level the stove, lift the stove up and unscrew each leveling bolt the appropriate amount. The
rubber tips of the leveling bolts will tear if they are adjusted while weight is applied to them.
P EDESTAL
Unpack the box containing the pedestal and check for any damage. Report any damage to your
dealer.
Slide the wood trim included with the pedestal on to the front and back edge of the pedestal so it
lines up from side to side. Place the pedestal in place and lift the stove on top of it. Line up the
threaded bolt holes in the bottom of the stove with the two holes on the tabs on the inside edge of
the pedestal (see the illustration below). Using a 9/16" socket wrench, fasten the pedestal to the
stove with the supplied bolts and washers. If installing in a mobile home, the pedestal will need
to be attached to the floor. Insert the two included lag bolts through the pedestal base and screw
them into the floor with a 1/2" socket wrench.
Holes for attachment bolts
17"
23"
If installing in a mobile home, insert
the lag bolts through the holes in the
baseplate and screw them into the
floor with a 1/2" socket wrench.
Screen, insulation, and
staples (used for wood
stoves - discard these items)
Attachment Bolts and
Washers - use a 9/16"
socket wrench to
attach the pedestal to
the stove.
Lag Bolts
The faceplate of the
stove is 11/4" in
front of the pedestal
NOTE: Replace the two front bolts that hold the "hold-down brackets" into the
baseplate after the metal brackets have been removed -- This prevents air from
entering through these holes.