Avalon Firestyles 900 PI-1993 to 1996 - Manual (Page 21)

I
NSERT
I
NSTALLATION
(C
ONT
.)
P AGE 21
Installing the Panels, Trim, and Switch Box (Continued)
The side
panels clip
into place on
the side of
the insert.
The switch box clips into place into the square
hole on the left side panel. Then attach the
electrical connector on the end of the cord to the
electrical connector on the left side of the insert.
The top panel slides over the flanges on the
side panels and over the top of the insert.
The left side
panel has a
square hole
in it for the
switch box.
The top panel then slides over the flanges on the side panels and over the top of the insert.
NOTE: The panels have a 3/8" standoff to keep the panels spaced off the fireplace facing.
This space is needed to allow air to flow into the fireplace. Do not remove this
standoff or seal the space between the panel and the facing.
CROSS SECTION OF BRASS TRIM
Set-screw that
holds the larger "L"
bracket in place
Groove where the larger
"L" bracket fits into
Groove Where Top
Panel Fits Into
Groove where the smaller
"L" bracket fits into
Front Side
Larger "L"
Brackets
Top Trim
Smaller "L"
Brackets
Left Trim Right Trim
Insert
Lay the trim on
the floor in front of
the insert with the
rounded portion
facing down.
After the panels are in place, the trim can then be installed. Place the rounded edge of the trim
that will be facing outwards when installed face down (see the illustration above). Insert one
small and one large "L" bracket leg into the grooves in the 45
o cut end of each side piece. Slide
the other leg of each "L" bracket into the groove in each end of the top piece. With a
screwdriver, tighten the set-screw into the larger "L" brackets, insuring that the 45
o cuts are
butted together to form a neat joint. Pick up the brass trim and slide it over the panels until the
bottom of the trim is flush with the bottom edge of the side panels.