Chapter 3 dvr installation, Nstallation, Amera and – Bolide SVR9004HD User Manual
Page 15: Onitor, Onnection, Ower, Upply connection, 1 hdd installation, 2 camera and monitor connection, 3 power supply connection
User Manual
11
Chapter 3 DVR INSTALLATION
3.1 HDD Installation
Caution： Please do not Install or take out hard drive when DVR is running!
(1) Cut power firstly, and then remove screws and open DVR upper cover carefully;
(2) Insert Power Cord and data cable into Pin of hard drive securely;
(3) Fix the HDD to DVR body
(4) Put the upper cover back carefully, re-attach screws.
Note: If user requires higher performance HDD, strongly recommend you use special hard driver for
security and protection
3.2 Camera and Monitor Connection
Connect camera cable to video input of DVR, and from video output of DVR to Monitor via BNC connector
(Refer to section2.2-Rear Panel); or VGA and HDMI monitor.
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of DVR
respectively (refer to system figuration on Chapter 8).
3.3 Power Supply connection
Please only use the power adapter supplied with the DVR.
After power on please make sure the video I/O connection well, audio device with RCA cable.