Cadac CDC four - Manual (Page 4)

4
Revision 1 2012-13 CDC FOUR
GENERAL PRECAUTIONS
• Do not place heavy objects on the control surface, expose it to sharp objects
or handle the console in any way that may cause damage, e.g., rough
handling and/or excessive vibration.
• Do not subject the equipment to dirt, dust, heat or vibration during operation
or storage. Never expose the console to rain or moisture in any form. Should
the console become wet, turn it off and disconnect it from the mains without
further delay. The console should be given sufficient time to dry out before
recommencing operation.
• When cleaning the console, never use chemicals, abrasive substances or
solvents.
• The console control panel should be cleaned using a soft brush and a dry
lint-free cloth. For persistent marks, use a soft cloth and isopropyl alcohol.
Switches and potentiometers do NOT require cleaning or lubrication. For
faders, see below.
• Keep these instructions for future reference. Follow all warnings in this
manual and those printed on the console.
• The console must be connected following the guidance in this manual. Never
connect power amplifier outputs directly to the console. Connectors and
plugs must never be used for any other purpose than that for which they are
intended.
• The console mains input must always be connected to correctly rated mains
power as referred to in this manual. The mains input must, at all times, be
connected to the local mains power supply using the supplied power cord.
In cases where the supplied plug does not fit, a qualified electrician must be
consulted.
• The power cord must be routed in such a way that the risks of accidentally
stepping on it, stretching it or it being pinched are minimized.
• WARNING ! THIS EQUIPMENT MUST BE EARTHED !
• Ventilation slots must never be covered or obstructed in any way, otherwise
airflow required for safe operation may be restricted. Where the console is to
be operated in its flight-case, then this must be located in such a way that it
allows for proper ventilation.
• Refer servicing to qualified technical personnel only.