Solo system metering and levels, Sip mode – Cadac CDC four User Manual

Page 65

Advertising
background image

Revision 1 2012-13

CDC FOUR

65

Solo system metering and levels

DAC

DAC

DAC

DAC

DIM

14dB

DIM

14dB

MIX

0dB

MIX

0dB

MIX

0dB

MUTE

LISTEN

LEVEL

AFL/PFL

AFL/PFL

Stereo Left

Stereo Right

MONITOR

OUTPUT

LEFT

MONITOR

OUTPUT

RIGHT

MUTE

MUTE

MONITOR

OUTPUT

MONO

MUTE

LISTEN

LEVEL

FRONT

PANEL

HEADPHONE

Buffer

10dB

Buffer

10dB

LEVEL

LEVEL

Bal OP

0dB

Bal OP

0dB

LEVEL

Bal OP

0dB

LEVEL

LEVEL

The solo signals are fed into the mixer’s monitoring system, where they are routed

to the rear panel Monitor Outputs (both as stereo and as a mono sum), and the

stereo headphone socket under the front armrest.

The front headphones output has its own volume control (PHONES) and mute

(M) button.

Signals solo’d in PFL mode will generally be at a higher level than those solo’d in

AFL mode, so separate trim adjustments are also provided for the AFL and PFL

systems. These are on-screen controls, and can be found in the Solo module of

the SYSTEM screen page.

SIP mode

The PFL and AFL modes described above are only monitoring modes, and do

not alter any other signal routings through the mixer. They are non-destructive,

and can be used safely during performance or recording without endangering any

other outputs from the mixer.

A further solo mode, SIP (Solo-in-Place) is available which is destructive. This

mode is also often referred to as ‘Check Solo’. SIP mode is enabled by pressing

the SIP button.

In SIP mode, soloing any input channel mutes every other input channel; thus

the soloed channel is the only one left feeding the master output (or Group, if

applicable). Thus it is ‘truly’ soloed, by virtue of all other signals being removed.

This mode is useful when setting up for performance or recording, but should

clearly be used with great caution otherwise!

Solo In Place mode may be selected On or Off by pressing and holding the SIP

button for at least 3 seconds, or clicking or its on-screen equivalent. When Solo

In Place is On, pressing a SOLO button anywhere on the mixer mutes all other

channels.

Mono PFL and stereo AFL meters are also provided on the SYSTEM page.

TALK

BACK

60

0

+

+

PHONES

MONITOR

-

-

M

SUM

M

SOLO LOGIC

CLEAR

HOLD

SIP

Advertising