Cadac CDC four - Manual (Page 40)

40
Revision 1 2012-13 CDC FOUR
FX Sends:
The groups cannot send to the internal FX processors. All FX Send controls are
inoperative and their virtual counterparts do not appear on-screen.
Routing and metering section:
Any of the four groups may be routed to the main LR stereo buss, permitting their
use as subgroups. The groups default with this routing enabled. The PAN control
is always in circuit, and with the control at its centre position (50/50, the default
value), the mono group signal feeds the left and right legs of the main stereo buss
equally, and is thus in the centre of the main stereo image. Full left-right panning
is possible, using either the PAN control on the CAM or via the screen using the
ADJUST control. However, the pan control IN button is disabled.
1 - 4 – the four group routing buttons 1 to 4 are not available to groups; thus it is
not possible to route a group to another group (or itself!).
L & R – a group may be routed to either the left or right legs of the main stereo
buss individually, though the setting of the PAN control will affect the level (i.e.,
routing to L and panning fully right will result in no signal).