Cybex 625T Treadmill - Manual (Page 36)

Scans for available TV transmitters, or will seek the next strongest
FM station or FM transmitter frequency.
Display option key 8
Stores and exits setup STOP key 9
When storing FM presets, this button will clear all stored FM radio
presets.
Setup key 10
Enters menu, accepts value shown, moves forward in menu. Enter key 11
Navigates TV channels or manually tunes FM frequencies Up/Down keys 12
A/V setup mode
Falling hazard. When starting unit
• Stand on two top steps.
• Do not stand on belt.
1. Plug the power cord into a power outlet from a grounded, dedicated circuit as described under
Electrical Requirements in this chapter.
Do not stand on treadmill during this procedure.
2. Ensure the power cord is not being pinched under the front of the treadmill.
3. Toggle the power switch on (|).
Power switch is located under the front end of the treadmill. The control panel will lightup and be in
the Dormant Mode.
4.
Press and the hold the Scan/Hold or Display option and UP keys for 3 seconds.
Display will show clock icon.
5.
Press Down to navigate to the A/V screen.
6. Press Enter to enter setup mode.
7.
Press the Up or Down keys to change A/V type from none to UHF, FM, or C.A.B. (Console
Adapter Box for Broadcast Vision). If C.A.B. is selected, no further setup is required.
8. Plug in headphones to listen for channels during setup.
Setup UHF Transmitters
For transmitter types 900 MHz, 863 MHz or 806 MHz. Use this procedure to associate channel numbers
to your TV transmitters. If using an FM transmitter system, skip to Setup TV FM Transmitters.
Pick transmitter type
1. Enter A/V setup mode.
2.
Select UHF and press the ENTER key.
Page 36 of 88
Cybex 625T Treadmill Part Number LT-23221-4 H