Datatek IPv6 Transformer User Manual - Manual (Page 38)

S E C T I O N 8 W E B G U I S Y S T E M
38
8.2 Interface Setup
The Interface setup form is used to configure the host-side and network-side interfaces of the
Transformer and the IPv4 address of the legacy device and the proxy IPv6 address of the legacy
device.
There are two interfaces on the Transformer, a host-side interface and a network-side interface. If
the legacy device is manually configured, its configuration should be set up to match the
configuration entered in this form. If the legacy device is configured to receive its configuration
automatically, the values it receives come from the entries in this form
.
Figure 13. Interface setup screen shows all the configuration fields and options.
8.3 Host-side
Device IPv4 address
This is the IPv4 address of the legacy device.
Transformer IPv4 address
This is the IPv4 address of the Transformer’s host-side interface.
8.4 Network-side
Device IPv6 address
This is the IPv6 proxy address of the legacy device. This IPv6 proxy address is bound to the IPv4
address of the legacy device. In translating IPv4 packets from the legacy device, the IPv4 device
address is translated to the IPv6 proxy address.
Transformer IPv6 address
This is the IPv6 address of the Transformer. This is one of the addresses to which the web
browser may connect in order to talk to the Transformer’s web server. The other address the
web browser may use is the Transformer IPv4 address.