Datatek IPv6 Transformer User Manual - Manual (Page 86)

S E C T I O N 1 0 W E B G U I D I A G N O S T I C S
86
10.11 Factory defaults
The Factory defaults form provides the means to clear out the current configuration
and restore it to the defaults that were shipped from the factory.
Use the Diagnostics Backup/Restore form first to save a copy of your configuration. After
clearing the by responding ‘Yes’ to the question, ‘Are you sure you want to proceed’ the
Transformer will automatically reboot. After rebooting, the Transformer Console Menu must be
used to enter the IPv6/Host and IPv6/Network addresses necessary to access the webGUI again.
Figure 48. Factory defaults Screen is shown below.
Setting the unit back to the factory defaults will remove the authorization code and a new one will need to
be obtained from Datatek
Figure 48. Factory defaults Screen